EN – 30
Install Gearcase Assembly
1.
Secure impeller to impeller shaft with two roll pins.
2.
Reinstall one flat steel washer onto each auger shaft
end.
3.
Reinstall support brackets to gearcase and secure
with two external tooth locking bolts. See Figure 66.
4.
Reinstall augers. See
5.
Reconnect spark plug wire.
IMPELLER REPLACEMENT
Remove Impeller
IMPORTANT:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire.
3.
Remove auger housing. See
Remove hardware securing attachment drive pulley to
impeller shaft.
5.
Remove pulley and spacer from impeller shaft.
6.
Loosen, but DO NOT remove bearing plate hardware.
7.
Remove hardware securing auger bushings to auger
housing. See Figure 52.
8.
Remove auger assembly from housing. See
Figure 54.
Remove two roll pins securing impeller to impeller
shaft and remove impeller.
IMPORTANT:
Use of penetrating oil or heat may be
necessary to remove impeller.
Figure 66
Figure 67
1. Bearing Plate
