EN – 31
Install Impeller
Apply a thin layer of anti-seize compound to impeller
shaft.
2.
Secure impeller to impeller shaft with two roll pins.
3.
Reinstall auger assembly into housing and seat
impeller shaft in ball bearing at housing rear. See
Figure 60.
4.
Secure support bushings to auger housing with six
tapping screws. See Figure 69.
Tighten three hex nuts securing bearing plate to
housing.
6.
Apply a thin layer of anti-seize compound to impeller
shaft end.
7.
Reinstall spacer bushing onto impeller shaft.
8.
Reinstall attachment drive pulley onto impeller shaft
and secure with locking washer and hex bolt. Torque
to 7.9 N•m – 16.5 N•m (5.8 lb-ft – 12.2 lb-ft).
9.
Reinstall auger housing to frame. See
10. Reconnect spark plug wire.
Figure 68
Figure 69
Figure 70
1. Spacer Bushing
2. Bearing Plate
