EN - 7
TOOLS REQUIRED
• Box knife to cut carton
TO REMOVE UNIT FROM CARTON
1. Cut off top of box.
2. Remove packing material.
3. Remove literature pack, safety glasses
and bottle of oil from box.
4. Cut out back of box and pull the unit out.
5. Remove protective packaging materials
from trimming head and around unit.
ASSEMBLY
Handlebar Assembly
1. Loosen handlebar wing knobs. Do not
remove them.
2. Unfold handlebar to operating position.
NOTE:
Adjust handlebar to a height
comfortable for the operator. Be sure cable is
clear of pinch points. Refer to
Handlebars
in
Service and Adjustments.
3. Tighten handlebar wing knobs to secure
upper handlebar.
Engine Crankcase Oil
Fill engine crankcase with proper amount and
viscosity of oil. Refer to Engine Manual for
specific information.
CHECKLIST
Please complete the following checklist before
proceeding:
• All assembly instructions have been
completed.
• No remaining loose parts in carton.
• Handlebar is adjusted comfortably and
tightened securely.
While learning how to use your unit,
pay extra attention to the following
important items:
• Trimming line is fastened securely in
holder.
• Fuel tank is filled with proper fuel.
• Engine crankcase is filled with oil.
• Become familiar with all controls – their
location and function. Operate them
before you start the engine.
ASSEMBLY
WARNING:
AVOID INJURY.
Read and understand the entire
Safety
section before
proceeding.
1. Lower Handle Bar
2. Upper Handle Bar
3. Carriage Bolt
4. Wing Knobs
5. Bolt Holes
6. Control Bail
Figure 3
Summary of Contents for 946152
Page 21: ......
