ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2051179-INS-R
B
•
PAGE 2
Step 1
Starting on the driver side, locate
the three mounting locations along the
bottom edge of the vehicle body.
Step 4
Locate the rear mounting tab and insert
two M10 bolt plates. Slide two plastic bolt
retainers over the threads of the bolts to
hold the bolts in place.
Place the rear bracket onto the
vehicle and secure with two M10
flat washers, lock washers and hex nuts.
Step 2
Remove any plugs from the mounting location.
Insert an M10 bolt plate into each of the
mounting points on the vehicle frame. Slide
a plastic bolt retainer over the threads of the
bolts to hold them in place.
Place the front driver-side mounting bracket
onto the vehicle and secure with an M10 flat
washer, lock washer and hex nut.
Snug the hardware,
but do not fully tighten.
Step 3
Locate the middle mounting locations for the
middle bracket. Secure the bracket to the
vehicle using M6 screws and flat washers.
Snug the hardware,
but do not fully tighten.
