Step 1
Locate the five mounting tabs along
the bottom edge of the vehicle body.
This installation will use the first
and fifth mounting tabs.
Step 2
Starting at the front driver side mounting
location, locate the threaded hole on the
inside of the body panel.
Attach the bracket to the body panel
using an 8mm hex bolt, lock washer
and flat washer.
The bolt should only be finger tight
to allow for adjustment later in the
installation process.
Step 3
Secure the bracket with a second 8mm
hex bolt, lock washer and flat washer
using the factory threaded nut on the
edge of the body panel.
Step 4
Locate the fifth tab location from step 1.
Insert a clip nut through the access hole
and align it over the adjacent small hole
and over the lower mounting tab.
Secure the bracket to the vehicle with
an 8mm hex bolt, lock washer and flat
washer in each mounting location.
