ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2055117-INS-RA
•
PAGE 2
Step 1
Starting on the driver side, locate
the three mounting tabs along the
bottom edge of the vehicle.
Step 4A - AdvantEDGE
™
Side Bars
Carefully place the side bar
onto the mounting brackets.
Align the edge of the side bar with
the outer edge of the mounting brackets.
Locate the round slots on
the base of the side bar.
Insert two black M8 hex bolts
into the rail slots for each bracket.
Step 2
Starting at the front mounting location,
remove any debris from the factory studs.
Attach a mounting bracket using an
M8 flat washer, lock washer and hex nut.
Note:
Apply anti-seize to the
studs to keep nuts from seizing up.
Repeat this process for the middle
and rear mounting locations.
Snug the hardware, but do
not fully tighten at this time.
Step 3
Repeat step 2 for the front, middle and rear
mounting locations on the passenger side.
If installing RidgeStep
™
running boards, skip to Step 5A
