ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2057975-INS-R
B
•
PAGE 2
Step 1
Place the mounting plates into
the track on the running board.
Carefully place the running board
onto the mounting brackets.
Slide the mounting plates along
the track to align with the mounting
brackets on the vehicle.
Secure the running board to the mounting
brackets using two M8 hex bolts, two
lock washers and two flat washers.
Note:
The number of mounting brackets
may vary based on application. Use one
mounting plate per bracket.
Step 3
Repeat all steps for the
passenger side of the vehicle.
Congratulations on the installation of your
new ARIES AscentStep
™
running boards.
With the running boards installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
first page of this installation manual.
Representative Image
Mounting plate
Mounting
plate
M8 hex bolt
M8 flat washer
M8 hex bolt
M8 flat
washer
M8 flat washer,
lock washer
Step 2
At this time, adjust the running board to the desired location.
With the running board in position, it is recommended to tighten all
brackets to the vehicle first, followed by the running board connections.
For recommended torque specifications, refer to the table on page 1.
