PAGE 3 • 2500201-INS-RF • 800.798.0813 • NEED ASSISTANCE?
•
ARIESAUTOMOTIVE.COM
Step 6
Hold the plastic inner fender flare in place
and mark for trimming. Cut carefully and
check the fit. Place the flare aside when
finished.
Step 5
Insert the the rivnut into the drilled hole.
Using an open ended 13mm wrench,
hold the M8 nut on the thread setting tool.
With a 13mm socket, turn the head of
the bolt clock-wise until the M8 nut and
metal spacer contact the M6 washer
and rivnut. After tension is felt, carefully
compress the rivnut in the hole while
applying slight pressure to keep it seated
(approximately two full rotations).
WARNING:
Over tightening the rivnut may
damage the thread set tool and / or vehicle
rocker panel. Only compress the rivnut
enough to seat in the hole without rotating.
Step 7
Lift the ARIES rear fender into place and
thread on the supplied 6mm bolt, locking
washer and flat washer.
Step 8
Reinstall the inner fender well using
the stock hardware where applicable.
To ensure a tight fit, additional
fastening may be required with
zip ties (not included).
