ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
3020000-INS-RB
•
PAGE 2
Step 1
Turn power to the running board system off
by turning off the cut-off switch.
Strip the insulation from the ends of both wires
on each push button extension harness. Insert
the bare wires into the spade terminals and
crimp the narrow end over the bare wires.
Step 2
Choose a location for the push button switch.
We recommend the plastic trim piece on the
door pillar.
If this is the location you choose, remove
the plastic trim piece to install the switch.
Step 3
Drill a hole for the switch in the trim piece. We
recommend using a step-up drill bit to get the
tightest fit. If a step-up bit is not available, use
a 7/8" drill bit.
Drill the hole until the switch will push in with
slight resistance. Push the switch into the hole
from the top down. The switch will secure itself.
