2.5. CHANGE OF THE TYPE OF GAS
It must be done by an authorized installer
ATTENTION: If the type of gas or pressure is modified, the nameplate that is attached to
the spare parts on the back of the plate must be placed, overlapping the previous label,
thus allowing to identify without any ambiguity the state of the iron after the modification.
BARBECUE BURNER
1º
Remove the 4 screws A
2º
Remove burner B
3º
Remove the injector C
4º
Place the new injector
5º
Replace burner B
6º
Place screws A
Proceed in the same way for the rest of
the
burners
FRYTOP BURNER
1º
Turn the griddle over
2º
Remove the injector A
3º
Proceed to change the injector
2.6. PRIMARY AIR REGULATION
In this device it is not necessary to regulate the primary air.
2.7. REGULATION OF THE MINIMUM
Turn on the burner and place the knob on the small flame or on the No. 1 for thermostatic
valve. Remove the knob from the tap “gently pulling on it”; A screw located on the left
side of the shaft will be visible.
Use a slotted screwdriver to turn the screw clockwise to reduce the height of the flame
and counterclockwise to increase it.
18
