13
LINEARIS
The hand wheel may be operated only in power-off condition.
1. Switch off operating voltage of the actuator and if equipped with gear disengagement,
move this to „Manual“ position.
2. Push hand wheel H into position V and turn in the desired direction. (Control cams
of position switches and potentiometers are also turned with it. Set positions are
retained).
3. After reaching the desired position let the hand wheel H go (it returns automatically to
its initial position R).
To avoid overrunning position switches and the potentiometer during manual operation, set
the limit positions of the actuator mechanically.
6.
Required customer information
6.1
Extraordinary situations
Run frequent testings during operation. Observe especially:
•
Intended use of the actuator (chapter 3.1);
•
unusual noise, heavy vibration or high temperatures;
•
check screws for tight seat;
•
check cable entries, cable glands and blank plugs for tight seat and possible leakness;
•
condition of electric wires.
If failure appear, set the actuator out of order and correct the error.
If you can not correct the error, contact an ARIS service person.
More information under: www.stellantriebe.de
6.2
Troubleshooting and repair
Hazardous voltage: Possible stroke!
•
Troubleshooting and repair only by experts!
•
Cut off voltage before opening the actuator.
Moving parts at built-on valves: Possible bruise!
•
Troubleshooting and repair only by experts!
We recommend a repair at the ARIS factory.
More information under: www.stellantriebe.de
ADVICE
!
CAUTION
WARNING
ADVICE
!
H
Y
R
V
ADVICE
!
ADVICE
!
