4
LINEARIS
1.2
Guidelines and standards
ARIS actuators are partly completed machinery according to directive 2006/42/EC. This is certified by a declaration of incorporati-
on (see page 14).
Further applicable EC directives:
EMC Directive 2004/108/EC
Applied harmonized standards:
LVD (electrical safety)
DIN EN 61010-1:2011-07
MachDir
DIN
EN
12100:2011-03
2.
Safety information
2.1
Warnings
Observe the significance of the following symbol and note explanations. They are subdevided in security levels and classified
according to ISO 3864-2.
DANGER indicates a hazard with a high risk degree, which, if not avoided, causes death or
heavy injuries.
WARNING indicates a hazard with a medium risk degree, which, if not avoided, can cause
death or heavy injuries.
CAUTION indicates a hazard with a low risk degree, which, if not avoided, can cause slight
or moderate injuries.
Indicates general advices, useful hints and work recommendations, which don´t have
influence on the safety and health of the staff.
2.2
General safety advices
The actuator components are conform to the state of the art and apply as generally safe at the time they are shipped.
This manual serves as basis to install and operate ARIS actuators safety conform. All persons working with or on ARIS actuators
must observe this manual and especially its safety advices.
•
This manual has to be kept at the operating place at any time.
•
Read the manual carefully prior to installation and initial operation.
Certain parts of active electric appliances are obligatory under voltage.
DANGER
ADVICE
!
CAUTION
WARNING
ADVICE
!
WARNING
