12
Tensor
Supply connection
N Neutral
L
Phase / Supply 85 ... 265 V AC
Connect the ground wire to the housing.
Conctrol connection
2
Control connection > left-turning
3
Control connection > right-turning
The control terminals have a function only if the tensor electronics is operated without the
controller module I-ACT (PMR).
The drive must be permanently energized, otherwise the holding torque is not available!
5.
Actuator operation without controller and display module (Standard)
5.1
Operation
5.1.1
Buttons and switches
The buttons (1) are marked with
LEFT [L]
MENU [M]
RIGHT [R]
Switch (2) changes between automatic and manual mode.
In MANU position the setup operation can be turned on
from manual mode.
5.1.2
LED displays
The LEDs on the operation module show information by
flashing or blinking.
ADVICE
!
CAUTION
On/Off
Blinking