Quick Start Guide: 720XP Series 2 RU Cognitive Campus Switches
7
Chapter 3
Rack Mounting the Switch
Important!
The rack mounting procedure is identical for all switches covered by this guide. Illustrations in this
chapter depict the mounting of a DCS-7050SX-128 switch.
Les procédure de montage du bâti est identique pour tous les commutateurs visés par ce guide.
Illustrations dans ce chapitre montrent le montage d'un interrupteur de DCS-7050SX-128.
•
provides instructions for mounting the switch in a two-post rack.
•
provides instructions for mounting the switch in a four-post rack.
After completing the instructions for your rack type, proceed to
3.1
Two-Post Rack Mount
To mount the switch onto a two-post rack, assemble the mounting brackets to the chassis, then attach
the brackets to the rack posts. Two-post accessory kits includes 2 three-hole mounting brackets.
Each chassis side has attachment pins that align with bracket holes; the number of pins (six or seven)
varies by switch model. Pin orientation is symmetric and equidistant, supporting bracket placement
where the flange is either flush with the front and rear panels, or not flush with the panels. Each bracket
hole includes a key-opening for placing the bracket flush with the chassis and then locking it into place.
Important!
Attachment pins must engage all three upper bracket holes.
Goupilles de fixation doivent s’engager tous les trois trous de la bride supérieure..
displays proper bracket mount configuration examples.
displays improper bracket
mount configuration examples.
Figure 3-1: Bracket Mount Examples for Two-Post Rack Mount