10
Quick Start Guide: 720XP Series 2 RU Cognitive Campus Switches
Four-Post Rack Mount
Chapter 3: Rack Mounting the Switch
Figure 3-6: Improper Bracket Mount Example for Four-Post Rack Mount
Off-set mount is always an improper bracket mount configuration on switches that have six attachment
pins on each side.
3.2.1
Extracting the Brackets and the Rails
displays a bracket-rail assembly and the component pieces (bracket and rail) that are
extracted from the assembly. Each assembly must be separated into its component pieces before
mounting the switch into a four-post rack. The two assemblies supplied with the switch are identical.
Figure 3-7: Bracket-Rail Assembly – Before and After Extraction
This procedure separates a bracket-rail assembly into its component pieces.
Step 1
Grip the rail with your right hand, as shown in
. Pull the bracket flange away from
the rail flange with your left hand until the bracket clip catches on the rail (
If the bracket flange resists initially, verify the thumb screw on the bracket flange is not attached
to the rail flange.