Quick Start Guide: 7368x Series Modular Data Center Switches
13
Chapter 4
Powering the Modular Switch
Important!
Installation of this equipment must comply with local and national electrical codes. If necessary, consult
with the appropriate regulatory agencies and inspection authorities to ensure compliance.
Installation de cet équipement doit être conformes aux codes électriques locaux et nationaux. Si
nécessaire, consulter les organismes de réglementation appropriés et des autorités de contrôle pour
assurer la conformité.
The switch operates with multiple power supplies. Refer to
for information
regarding your specific system.
lists the quantity of modules each chassis can contain and
the minimum operating requirements for each model.
displays the location of the power supplies on the rear panel of the switch. Unpopulated
power supply bays must be covered using the appropriate “blank” for the switch.
This chapter includes sections that describe procedure for grounding and cabling power supplies. After
completing the instructions for your switch, proceed to
Important!
Read all installation instructions before connecting the system to the power source.
Lire toutes les instructions d'installation avant de brancher le système à la source d'alimentation.
•
Non-Redundant Configuration:
Provide power to the minimum required power inputs.
•
Redundant Power Supply Configuration:
Connecting power to modules in excess of minimum
requirements protects the switch against failed modules and can provide grid-level redundancy.
•
Power down the Switch:
Remove all power cords from the power input sockets.
Important!
This equipment must be grounded. Never defeat the ground conductor. This unit requires over-current
protection.
Cet équipement doit être mis à la terre. Ne jamais modifier le conducteur de terre. Cet appareil
nécessite de protection contre les surintensités.
Table 4-1 Power Supply Capacity and Requirements for 7368X4 Series Modular Switches
Switch Model
Chassis Capacity
(Power Supply Units)
Minimum Operating Requirements
(non-redundant power)
DCS-7368X4
4
1 active circuit
Summary of Contents for 7368X Series
Page 32: ...28 Quick Start Guide 7368x Series Modular Data Center Switches Appendix C Front Panels ...
Page 34: ...30 Quick Start Guide 7368x Series Modular Data Center Switches Appendix D Rear Panels ...
Page 36: ...32 Quick Start Guide 7368x Series Modular Data Center Switches Appendix E Line Cards ...