22
Quick Start Guide: 7368x Series Modular Data Center Switches
Line Card Module Indicators
Appendix A: Status Indicators
(1):
If all Status LEDs are OFF, check the following: power feeds are live, power supplies are installed,
Switch Card is properly seated, and Supervisor is properly seated. The system will not power up unless all four
of these conditions are valid.
A.2
Line Card Module Indicators
Each line card module provides one status LED plus LEDs for each port on the card. The figures in
indicate the location of the LEDs on each line card.
displays the status LED and
Port LEDs on the DCS-7368-16C-LC line card. Arrows indicate the port status being displayed by the
corresponding port status LED.
Figure A-2: Linecard Status LEDs (DCS-7368-16C-LC)
System
Green
All linecards are operating normally.
Red
At least one linecard has failed.
Switch Card
Green
Module is operating normally.
Red
Module has failed.
Fan
Amber
At least one fan is missing or has failed.
Green
All modules are operating normally.
Red
There are insufficient functional fans installed in the switch.
Table A-1 Supervisor LED States
(1)
(Continued)
LED Name
LED State
Module State
1
Linecard Port LEDs
2
Linecard Status LED
3
Linecard Ejector Latch
Summary of Contents for 7368X Series
Page 32: ...28 Quick Start Guide 7368x Series Modular Data Center Switches Appendix C Front Panels ...
Page 34: ...30 Quick Start Guide 7368x Series Modular Data Center Switches Appendix D Rear Panels ...
Page 36: ...32 Quick Start Guide 7368x Series Modular Data Center Switches Appendix E Line Cards ...