Appendix A: Status Indicators
Fan Module Status Indicators
Quick Start Guide: 7368x Series Modular Data Center Switches
23
The Line Card Status LED is in the center of the DCS-7368-16C-LC.
interprets the states of
the Status LED.
interprets the port LED states.
A.3
Fan Module Status Indicators
The fan modules are inserted into the switch card module. Each switch contains one switch card and
five fan modules.
displays the rear panel of the switch covered by this guide.The fan
module indicator is displayed in
. The fan handle color indicates the airflow direction. All fan
modules must have the same color handle.
Note
The orientation of the fan module as inserted in the switch may be different from the one shown.
Figure A-3: Fan Status LEDs
The
fan installation Indicator
is green when the fan module is properly installed or red when the
module is not fully installed.
interprets the states of the Fan Status LED.
Table A-2 Linecard Status LED States
LED State
Status
Off
Line card not inserted.
Green
Line card operating normally.
Amber
Line card administratively shut down.
Red
Line card has failed.
Table A-3 Linecard Port LED States
LED State
Status
Off
Port link is down.
Green
Port link is up.
Yellow
Port is disabled in software.
1
Fan Release Handle
2
Fan Installation Indicator
3
Fan Status LED
Table A-4 Fan and Fabric Status LED States
LED State
Status
Off
The module is inserted but not receiving power – it may not be properly seated.
Summary of Contents for 7368X Series
Page 32: ...28 Quick Start Guide 7368x Series Modular Data Center Switches Appendix C Front Panels ...
Page 34: ...30 Quick Start Guide 7368x Series Modular Data Center Switches Appendix D Rear Panels ...
Page 36: ...32 Quick Start Guide 7368x Series Modular Data Center Switches Appendix E Line Cards ...