16
2. DIN-Rail mounting
As shown in the figure below, please follow the steps to mount the ARD-1007TX HDMI
digital extender via DIN-Rail.
•
Step 1:
The two metal clasps are pre-installed on the back of ARD-1007TX HDMI digital
Extender, place one Din-Rail on the wall or board, and use a screwdriver to tighten the
screws to affix the Din-Rail onto the wall or board.
•
Step 2:
Snap the metal clasp by the built-in iron loop spring on the Din-rail to mount the
ARD-1007TX HDMI digital Extender onto the wall or board.
•
Step 3:
You can also slide ARD-1007TX around the Din-rail to move it to a desired
position.
•
To remove the ARD-1007 Extender from Din-rail, press the iron loop spring built-in the
metal clasp on the rail to loose it, then remove the ARD-1007 from the rail.
metal clasp
Din-Rail
Screws
