Arista ARP-2200AP User Manual
80
|
P a g e
Chapter 8 Maintenance and Troubleshooting
Regular maintenance of the ARP-2200AP Series industrial PC can help prevents damage or downtime.
Warning
! Do not operate or service the unit with its chassis open. There are hazardous voltages
inside. Service should only be performed by qualified and authorized personnel. Make sure your
industrial PC is powered down and unplugged before removing the cover or working on internal
components.
In order to ensure safe operation, you must observe the instructions and warnings contained in this manual.
The device must be used in accordance with the instructions for use.
The electrical installations in the room must correspond to the requirements of the respective regulations.
Take care that there are no cables, particularly power cables, in areas where persons can trip over them.
Do not use a power cable in sockets shared by a number of other power consumers. Do not use an extension cable.
Only use the power cord supplied.
The unit is only completely disconnected from the main power source when the power cord is disconnected either from the
power source or from the unit. Therefore, the power cord and its connectors must always remain easily accessible.
Only devices and components which fulfill the requirements of a SELV circuit (Safety Extra Low Voltage) may be connected
to the interfaces of the system.
All plugs on the connection cables must be screwed or locked to the housing.
Do not place the device in direct sunlight, near heat sources or in a damp place. Make sure the device has adequate
ventilation.
The device may be opened only for the replacement of the lithium battery and main memory. The device must be switched
off and disconnected from the power supply.
The extension of the device can be carried out only in the factory.
Maintenance or repair on the open device may only be carried out by qualified personnel authorized by Arista Corporation.
Only original accessories approved by Arista Corporation may be used.
It must be assumed that safe operation is no longer possible
o
if the device has visible damage or
o
if the device no longer functions
In these cases the device must be shut down and secured against unintentional operation.
Summary of Contents for ARP-2200AP SERIES
