Chapter 3
Rack Mounting an Awake Security Appliance
This chapter describes the rack mounting procedure that is identical for all Awake Security appliances
covered by this guide. Illustrations in this chapter depict the mounting of Awake 1RU and 2RU
appliances.
Ce chapitre décrit la procédure de montage en rack qui est identique pour toutes les appliances Awake
Security couvertes par ce guide. Les illustrations de ce chapitre décrivent le montage des appliances
Awake 1RU et 2RU.
The following sections provide instructions for mounting Awake 1RU and 2RU appliances:
•
Installing 1RU Awake Security appliances
•
Installing 2RU Awake Security appliances
3.1
Installing 1RU Awake Security appliances
Perform the following steps to install a 1RU Awake Security appliance:
1. Identify the left and right outer rails by examining the ends, which bend outward. Slide the matching
inner rails into the corresponding outer rails to be sure they are ready for installation.
Note: The rail set fits a rack between 25.6" and 33" deep.
2. Position the alignment pins in the rear rail (2) with the hole at the end of the slot in the front rail (1),
and slide the front section into the rear section (3).
Figure 1: Installing Rails
Note: Each end of the assembled outer rail includes a bracket with alignment pins to fit into
your rack holes.
3. Position the alignment pins on the front end of the rail with the holes on the front of the rack (C).
Push the rail into the rack until the quick release bracket snaps into place, securing the rail to the
rack.
Note: Be sure to mount the rails horizontally by referencing the number labels on the
vertical bars of the rack.
4. Adjust the rail to reach just past the full depth of your rack.
7
