Chapter 3: Rack Mounting the Switch
Four-Post Rack Mount
Quick Start Guide: 7000 Series 2 RU Data Center Switches
13
Figure 3-8: Extracting the Bracket-Rail Assembly
Step 2
While pressing the locking clip on the bracket (
Figure 3-8-Right
), resume pulling the bracket
from the rail until the separation is complete.
Step 3
Repeat the procedure for the other assembly.
3.2.2
Attaching Mounting Brackets to the Chassis
Figure 3-9
displays the front bracket alignment for mounting the switch into a four-post rack.
This procedure attaches mounting brackets to the switch chassis as depicted by
Figure 3-10 on page
14
.
Step 1
Align the mounting brackets with the attachment pins to obtain the desired mounting position.
Step 2
Place the bracket flush on the chassis with attachment pins protruding through key-openings.
Step 3
Slide the bracket toward the front flange until the bracket clip locks with an audible click.
Figure 3-9: Front Bracket Alignment
To remove the mounting bracket from the chassis
, lift the front edge of the mounting bracket clip
with a flathead screwdriver and slide the bracket away from the front flange (opposite from the
installation direction).
Summary of Contents for DCS-7050SX-128
Page 38: ...36 Quick Start Guide 7000 Series 2 RU Data Center Switches Appendix C Front Panel ...
Page 40: ...38 Quick Start Guide 7000 Series 2 RU Data Center Switches Appendix D Rear Panel ...
Page 44: ...42 Quick Start Guide 7000 Series 2 RU Data Center Switches Appendix F Taiwan RoHS Information ...