background image

AUS

3

Connecting the drain hose

Connect the drain hose to 
drain duct piping or a wall 
drain located between 65 
and 100 cm above the floor, 
making sure it is not bent 
at all.

Alternatively, rest the 
drain hose on the side of 
a washbasin or bathtub, 
fastening the duct supplied 
to the tap 

(see figure). 

The free end of the hose 
should not be underwater. 

!

 We advise against the use of hose extensions; if it is 

absolutely necessary, the extension must have the same 
diameter as the original hose and must not exceed 150 cm 
in length.

Electrical connections 

Before inserting the plug into the electrical socket, make 
sure that:  

•  the socket is earthed and complies with current 

regulations;

•  the socket can withstand the maximum load of the 

appliance, which is indicated in the Technical data table 

(see opposite);

•  the power supply voltage falls within the values indicated 

in the Technical data table (

see opposite

);

•  the socket is compatible with the plug of the appliance. 

If this is not the case, either the socket or the plug must 
be replaced.

!

 The machine must not be installed outdoors, even in 

covered areas. It is extremely dangerous to leave the 
appliance exposed to rain, storms and other weather 
conditions.

!

 Once the machine has been installed, the electricity 

socket should be easily accessible.

!

 Avoid using any extension cord or multiple socket outlet.

!

 

CAUTION: 

if this appliance is supplied from a cord 

extension set or electrical portable outlet device, the cord 
extension set or electrical portable outlet device 
must be positioned so that it is not subject to splashing or 
ingress of moisture. 

!

 The cable should not be bent or compressed.

!

 The cable should be replaced only by authorised 

technicians.

!

 If the supply cord is damaged, it must be replaced by the 

manufacturer, its service agent or similarly qualified persons 
in order to avoid a hazard.

Warning! The company shall not be held responsible in the 
event that these regulations are not respected.

65 - 100 cm

Technical data

Model

AQ9L 29 U

Dimensions

width 59.5 cm
height 85 cm
depth 64,5 cm

Capacity

from 1 to 8,5 kg 

Electrical 
connections

please refer to the technical data plate 
fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres

Spin speed

up to 1200 rotations per minute

Energy rated 
programmes 
according to 
AS/NZS 2040.2

Program Cotton 

; temperature 60°C;

1200 rpm, using a load of 8,5 kg.

This appliance conforms to the following 
EC Directives:
- 2004/108/EC (Electromagnetic Compa-
tibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC

Summary of Contents for AQUALTIS AQ9L 29 U













Reviews: