ARITERM SWEDEN AB
Installation, Operation & Maintenance -
2009.02.18- 31/32
After installation the burner has to be adjusted. To test every power range, press plus key for 8 seconds in On/Off menu, then can high, low and min modes be tested
manually. Returning to normal position: Press minus key once.
ATTENTION! In this function, the burner won’t stop when the boiler water reaches desired temperature: boiling risk!
If these instructions are not followed during installation, operation and maintenance,
the obligations of Ariterm AB under the warranty regulations are no longer binding.
Ariterm reserves the right to alter any details and specifications without prior notice.
INSTALLATION PROTOCOL
Flue gas temp. High
CO
O
2
CO
2
Air-fuel ratio
Efficiency
Draught i mm
Fan
Effect %
Flue gas temp. Low
CO
O
2
CO
2
Air-fuel ratio
Efficiency
Draught i mm
Fan
Effect %
Flue gas temp. Min
CO
O
2
CO
2
Air-fuel ratio
Efficiency
Draught i mm
Fan
Effect %
Retailer / Installer
Installed by
Inst. date
Summary of Contents for Biomatic plus 50
Page 10: ...ARITERM SWEDEN AB Installation Operation Maintenance 2009 02 18 10 32 WIRING DIAGRAM ...
Page 28: ...ARITERM SWEDEN AB Installation Operation Maintenance 2009 02 18 28 32 NOTES ...
Page 29: ...ARITERM SWEDEN AB Installation Operation Maintenance 2009 02 18 29 32 NOTES ...
Page 30: ...ARITERM SWEDEN AB Installation Operation Maintenance 2009 02 18 30 32 NOTES ...