PELLET STOVE KMP EKERUM / NEPTUNI
ARITERM SWEDEN AB
Installation Instructions -
2011.08.19
- 12
/24
Fig. 8
2.5 Electrical connection
The back of the stove is equipped with a
1.5 m long cable with plug, which must
be connected to a 230 V 50 Hz, earthed,
mains supply. The internal wiring diagram
is shown in fig. 8.
NOTE!
If the connection cable is damaged
it must be replaced by one of the same
type, contact the dealer.
2.6 Documentation
The stove must be installed, inspected and
commissioned by an authorised engineer.
At installation, the following data must be
collected and gathered under the section
Warranty and Installation proof.
• Manufacturing number
• Installation date
• Vacuum in chimney (cold)
• Vacuum in chimney (hot)
• Outdoor temperature
• Smoke gas temp at max operation
• Carbon dioxide content (CO
2
)
• Distance to combustible material
Trafo
230 VAC
J3
J4
J1
J8
J5
J1
0
R
S4
85
J6
J9
PE
röd
vit
orange
orange
1/
2
6/
7
9/
10
4/
5
230 VAC
M
brown
grey
Convector fan
Feeder motor
black
blue
white
blue
Safety switches
white/glass fiber
brown
blue
FUSES
2 x 3,15 AT
yellow/green
Connector
black
black
Ignition unit
Combustion fan
Ignition element
Light sensor
black
black
brown
brown
red
black
red
black
red
black
orange
white
brown
blue
Control panel
red
black
Pressure switch
Drag (option)
Remote
(option)
PWM Out
Drag (option)
black
gray
brown
black
black
orange
Pressure switch
jumper
black
red
