PELLET STOVE KMP EKERUM / NEPTUNI
ARITERM SWEDEN AB
Installation Instructions -
2011.08.19
- 18
/24
4 Removal
4.1 Burner
1. Open the door and remove the ash box.
2. Remove the four screws holding the burner flange to the stove wall (fig 10).
3. Pull the burner straight out until the cables connecting the burner to the control circuit
board are visible. Pull the two connectors apart. The burner can now be removed.
4. Reinstall in reverse order.
4.2 Firing element
1. Remove the burner as above.
2. Remove the four screws (1) holding the upper part of the ignition bracket.
The firing element is now free.
3. Disconnect the firing element’s cables from the terminal block.
4.
Slacken off the screw (3) that secures the firing element. Remove the firing sleeve from
the element. Pull out the cables from the lead-ins.
5. Reinstall in reverse order.
4.3 Combustion fan
1 Remove the burner and the ignition console according to the Firing element section.
2. Remove the red and the blue cable from the terminal block on the side of the bracket.
3. Remove the screws (2) holding the fan to the bracket.
4. Reinstall in reverse order.
4.4 Flame detector
1. Remove the burner and the ignition console according to the Firing element section.
2. Remove the white cables from the terminal block in the side of the bracket.
3. Remove the flame sensor, but first note how it sits at the side of the bracket.
4. Reinstall in reverse order.
(1)
(3)
(2)
Burner
Flame detector
Combustion fan
Fig. 10
Drag
Standard
Terminal block
Terminal block
