PELLET STOVE KMP EKERUM / NEPTUNI
ARITERM SWEDEN AB
Installation Instructions -
2011.08.19
- 5
/24
Table of Contents
Product description
1.1
General
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5
1.2
Components
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
1.3
Technical data
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1.4
Control panel
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-8
1.5
Safety system
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
1.6
Settings
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
1.6.1 Control duration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Installation
2.1
Positioning
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.2
Chimney
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.3
Ventilation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.4
KMP Draft
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2.5
Electrical connection
. . . . . . . . . . . . . . . . . . . . . . . . . . . 12
2.6
Documentation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Operation and maintenance
3.1
Fuel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3.2
Ash removal
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3.3
Glass
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3.4
Sweeping
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
3.5
Hot air fan
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
15
3.6
Operating stoppage
. . . . . . . . . . . . . . . . . . . . . . . . . . .
15
3.6.1 Fault tracing and remedy
. . . . . . . . . . . . . . . . . . . . . . . 16
Removal
4.1
Burner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
18
4.2
Firing element. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
18
4.3
Combustion fan
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
18
4.4
Flame detector
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
18
4.5
Hot air fan
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
4.6
Control circuit board
. . . . . . . . . . . . . . . . . . . . . . . . . . . 19
4.7
Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
4.8
Overheat protection and safety switches
. . . . . . . . . . . . 19
Warranty
Warranty parts
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Declaration of conformity
. . . . . . . . . . . . . . . . . . . . . . . 21
1 Product description
1.1 General
The stove has been developed to work as a primary heat source. The stove’s high level of
efficiency, in combination with automatic operation, means that the stove replaces up to 80
% of the heating in a normal family house with electricity as heating source. The stove is
designed for firing with wood pellets and requires an electrical power supply. In the event of
a power failure, the stove requires power from another power source (optional extra).
The integrated convection fan distributes the hot air around the house, for best effect the
stove should be centrally located on the lower floor of the house. The room temperature
is easily set from the control panel. During thermostatic operation the stove is ignited and
extinguished automatically.
Pellets are filled through two hatches on the top of the stove. The filler hatches and door
are equipped with safety switches. Three safety thermostats are mounted together with the
switches in a safety coil to prevent overheating.
Connection to the chimney can be either upwards or to the reverse.
The stove must not be used as an incinerator and must only be fired using wood pellets
acc. to EN 14961.
NOTE!
The stove’s surfaces on and around the glass become extremely hot.
