To remove the loose baffle, lift the front edge until it hits the top and then slide it
forward. Then drop the rear edge and the baffle will slide down. To remove the
fixed baffle, loosen the two screws and slide it
forwards, it will then drop down.
To remove the cast iron liners, lift them clear
of the grate support plate and then move the
front edge of the casting towards the middle of
the stove, and clear of the back wall of the
stove, then tilt the casting so that it can be
removed diagonally through the opening.
Remove the flue spigot and gasket by removing
the four bolts.
Next, remove the grate by pushing it from
underneath, the riddling bar is not fixed to the
grate. This will allow access to four M6 fixings
which will attach the stove to the outer casing.
Remove the 4 fixings, allowing the insert stove
to be removed from the external casing.
2.4 Chimney
THIS PRODUCT IS SUITABLE FOR
CHIMNEY INSTALLATION ONLY
.
The stove is a radiant room heater and must
be connected to a chimney of the proper size
and type. The chimney must have a cross
sectional area of at least 124cm
2
or a diameter
of at least 150mm. Never connect to a smaller
size chimney. Do not connect to a chimney
serving another appliance. Minimum chimney
height 4.5 meters from floor on which stove is
installed.
It is recommended that a flue liner of diameter
150mm be used to line the chimney, the liner
should be approved for use with solid fuel.
See Fig. 1.
It is permitted to connect using a closure plate
and a connection piece from the stove to the
closure plate (See Fig 2), provided that the
chimney is of sound construction with no
leaks or cracks, a clay flue liner has been used
that can withstand up to 1000
o
C, the clay liner has a diameter no greater than 200mm.