Step 7
Lay the sealing gasket on to the flue spigot, then fit the flue spigot to the end of the
flexi flue liner using the 3 grub screws provided.
Step 8
Then using the M6 screws secure the stove to the convection chamber. Push the insert
stove against the fireplace before fully tightening these bolts.
Step 9
Push the flexi liner back up through the flue outlet and fix the flue spigot into position
using the M8 nuts provided. It may be necessary to cut a prop to hold the spigot in
place while the fixings are being attached.
Step 10
Complete the installation of the flexi line at the top of the chimney in accordance with
the manufacturers instructions.
Step 11
Fit the individual
components in the following
order:
1.
Back Bricks
2.
Grate Support
3.
Grate
4.
Loose Baffle
5.
Side Bricks
6.
Fire Fence
1.
Back Bricks
Lay the side and back bricks
in as shown.
2. Grate Support
Tilt the grate support up on
one side and pass it carefully
through the door opening, it
should then rest on three
supports
approx.
100mm
from the floor of the stove
grate.
