23
PREPARATIONS BEFORE BATHING PATIENT
Preparations before bathing patient
Preparations for bath
(8 steps)
1. Before using Classic Line 2 bathtub, make sure
that you have read the Safety instructions on
page 8 and Preparations on page 10
2. Lower Classic Line 2 bathtub to its lowest
position. See Figure 19.
3. Close the Drainage plug by turning the drain plug
control knob (A) counterclockwise. See Figure 20.
4. Set the desired temperature using the Water
temperature setting knob.
5.
3UHVVWKH%DWKWXE¿OOLQJ212))EXWWRQWRVWDUW
¿OOLQJ&ODVVLF/LQHEDWKWXE7KHDXWR¿OOIXQFWLRQ
VKXWVRIIWKH¿OOLQJZKHQWKHZDWHUKDVUHDFKHG
WKHDXWR¿OOVHQVRU$GGLWLRQDO¿OOLQJLVDFKLHYHGE\
SXVKLQJWKH%DWKWXE¿OOLQJ212))EXWWRQDJDLQ
See Figure 21.
6.
Put your bare hand in the water stream and make
sure the water temperature is not too hot or too
cold.
7. Check the temperature of the water in Classic
Line 2 bathtub on the temperature display.
See Figure 22.
8. If necessary adjust the temperature using the
Water temperature setting knob.
WARNING
To prevent scalding, always check the
water temperature with your bare hand
ZKHQ¿OOLQJWKHEDWKWXE'RQRWXVH
gloves as it may insulate to the extent that
the water temperature can be misjudged.
'LUHFWWKHÀRZRIWKHZDWHUDZD\IURPWKH
patient.
Figure 19
Figure 20
Figure 21
Figure 22
A
37.0°C