27
BATHE PATIENT USING A BATH LIFT CHAIR
Continue with the steps on next page
3. Make sure that the patient keeps holding on to the
driving handle.
4. To separate the bath lift chair from the bottom
of Classic Line 2 bathtub, lower Classic Line 2
bathtub to its lowest position or raise the bath lift
chair. See Figure 31.
5. Lift off the shower handle, hold it over Classic
Line 2 bathtub.
6. Direct the shower handle away from the patient.
7. Turn on the shower by pressing the Shower
ON/OFF button. See Figure 32.
8.
Put your bare hand in the shower water and make
sure the water temperature is not too hot or too
cold.
9. Check the temperature of the shower water on
the temperature display. Figure 33.
WARNING
To prevent scalding, always check the
water temperature with your bare hand
before directing the water onto the patient.
Do not use gloves as it may insulate to
the extent that the water temperature can
EHPLVMXGJHG'LUHFWWKHÀRZRIWKHZDWHU
away from the patient.
Figure 31
Figure 32
37.0°C
Figure 33
