39
CLEANING AND DISINFECTION
12.
Scrub the surfaces of Classic Line 2 bathtub,
loose parts and footrest with a soft bristle brush
RUFORWKWRUHPRYHDQ\GHSRVLWVHJVNLQÀDNHV
Scrub thoroughly, especially on handles.
See Figure 61.
13.
6RDNDFORWKLQGLVLQIHFWDQWÀXLG
14. Wipe all other contact areas outside of Classic
Line 2 bathtub (particularly behind the head),
shower handle and Water temperature setting
knob with the cloth.
15. Open the Drainage plug.
16. Rinse all parts clean with plenty of water having
a temperature of approximately 25 °C (77 °F) to
ULQVHRIIWKHGLVLQIHFWDQWÀXLG6HH)LJXUH
17. Wet a new cloth with water and remove all traces
RIGLVLQIHFWDQWÀXLGRQFRQWDFWDUHDVRXWVLGH
of Classic Line 2 bathtub. The cloth should
occasionally be rinsed in running water when
UHPRYLQJWKHGLVLQIHFWDQWÀXLG
Disinfect (step 18 to 29 of 29)
18. Spray disinfectant into the drain.
19. Close the Drainage plug.
20. Spray disinfectant on all internal Classic Line 2
bathtub surfaces, and the footrest at the bottom
of Classic Line 2 bathtub. Turn over the footrest
and spray on the other side. Pay attention to
parts, knobs and sensors attached to the bath
surface such as drain control knob and grab
handles. See Figure 63.
21. Soak a cloth in the disinfectant solution.
CAUTION
Never use an abrasive pad or steel wool
on the bathtub as it may scratch the
surface.
Figure 61
Figure 62
Figure 63
Continue with the steps on the next page
