Arjo EASYTRACK 9330010, Instructions For Use Manual

001.10610.EN rev

. 13

Assembling the EASYTRACK

8

Requirements

•  Step ladder

•  Tape measure

•  Someone to assist you

Assembling Procedure

1)  Remove the round blue cap from the top of 

each post by pulling them away from the 

post. 

Fig. 8

2)  Remove the blue 

plastic strips from 

each side of the 

posts. Take one end 

and pull gently.

Fig. 9 

3)  Place one round foot plate (see Fig. 2 - item 

№ 1) on the floor where you want to place 

the first post of the 

EASYTRACK

 System. 

4)  Take the pivot post 

(see Fig. 2 - item 

№ 2) out of the box 

and the post top for 

pivot post (see 

Fig.  2  -  item  №  5). 

Insert the post top 

into the post until it 

snaps into place.

Fig. 10 

5)  Take one of the 

posts out of the box. 

Turn the post 

upright. Place the 

clip-on level (see 

Fig. 2 - item № 16) 

onto the post at 

approximately waist 

height.

Fig. 11 

6)  Place the post onto 

the foot plate and 

press down to 

tighten. Pay attention 

to the shape of the 

post and foot plate 

before pressing the 

post down onto the 

foot plate. 

Fig. 12 

7) 

Place one top plate (see Fig. 2 - item № 6) 

into  the  top  of  the  post,  press  firmly  and 

evenly downward until the top plate “clicks” 

into place.

Fig. 13

8)  Extend the post 

quickly towards 

the ceiling by 

pulling the top 

portion and 

holding the 

bottom portion. 

The post should 

be within 76  mm 

(3”) to touching 

the ceiling. If the 

top of the post is 

more than 

76 mm (3”) from 

the ceiling: 

Fig. 14 

a)  Raise the top portion of the post slightly.

Assembling the 

EASYTRACK