Arjo Maxi 500, Instructions For Use Manual

How to use the Maxi 500 

9

Battery Charge Indicator

Fig. 10 

The battery charge 

indicator is a bar 

graph display, 

located on the 

battery pack holder, 

which shows the 

charge condition of 

the battery.
The lift is equipped  

with an audible   warning device, which will 

beep when the battery level reaches the critical 

range. 

CAUTION:

 When the indicator reaches the 

critical range, recharge the battery 

immediately to prevent reducing its lifespan.

When a fully charged battery is inserted into the 

lift, the display will return to the green fully 

charged position, regardless of the level the 

indicator had reached previously. However, if a 

partially charged battery is inserted, the 

previous indicator level will be maintained, even 

though the recently inserted battery may be in a 

better state of charge than indicated. To achieve 

a true indication of battery condition, a fully 

charged battery must be inserted into the lift. 

Battery Information

For safe handling and to extend the battery 

lifetime, please follow and remember these 

instructions.
The 

Maxi 500

 uses a 24 volts sealed lead-acid 

battery pack that can deliver up to 100 lifts per 

charge. 
Battery life is variable (2-3 years) and is 

LQÀXHQFHG E\ IUHTXHQF\ RI XVH IUHTXHQF\ RI

FKDUJLQJ WHPSHUDWXUH RI RSHUDWLRQ௘௘VWRUDJH

and storage time.
To prolong the battery pack life, recharge it 

before the indicator reaches the Low Battery 

range.
To ensure that the 

Maxi 500

 is always ready for 

use, it is recommended that a fully charged 

battery pack always be available. Do this by 

having additional battery packs, and keeping 

one battery pack charging while the other is in 

use.
Remove the battery pack from the lift when 

storing for an extended period of time. Stored 

batteries should be recharged at least every 

WZRZHHNVWRPD[LPL]HWKHLUOLIHVSDQ

Battery Charging

The battery should be recharged as soon as 

the discharge indicator displays amber.
Refer to the Wall Mounted Battery Charger - 

,QVWUXFWLRQV IRU 8VH ;; IRU

charging details.
Note that the battery pack may remain 

connected to the charger when fully charged.

,QVHUWLQJ௘௘5HPRYLQJWKH%DWWHU\3DFN

7KHVDPHPHWKRGDSSOLHVIRULQVHUWLQJ௘௘UHPRYLQJ

WKHEDWWHU\SDFNLQWR௘௘IURPWKHOLIWRUWKHFKDUJHU

Inserting the Battery Pack

1)  Align the bottom of the battery pack with the 

bottom of the battery support.

2)  Insert the battery pack until it rests into the 

support base.

3)  Push the top of the battery until it latches to 

the support.

Fig. 11

1

2

3

Removing the Battery Pack

1)  Push the release button.
2)  Pull the battery back.
3)  Lift the battery to pull it out of the battery 

rack.

Scale (optional)

To use the scale, if available, refer to the 

Scale 

IFU

.

Normal  
operating

Low
battery

Critical