Arkbird
- 2 -
1. Transmitter Tuner Mode:
1. Please refer to the remote control instruction, and set the remote TX to PPM output. (
Attention! If
it’s
set to PCM, it will not be identified
.)
2. Please t
urn off the remote control, insert the three wires of the ‘3S port’ in the bottom left corner
(black=ground wire, red=7-12V, white=PPM signal wire) into the remote control.
3. Please turn on the remote control after checking the wire connection. If PPM signal is identified, the
status LED of transmitter will flicker fast; otherwise it will flicker slowly (one second one time).
4. The transmitting power can be adjusted by spinning the ‘power adj’ knob at the top-right corner of
the transmitter.
2. Transmitter Repeater station mode:
1. Repeater mode provides a simple way to forward your 2.4G/72M receiver signal to the UHF
receiver, suitable for the transmitter placed far to avoid interference to FPV Video RX, please ensure
the UHF transmitter antenna vertically installed 1.5 m above the ground (A tripod is recommended).
2. Please refer to the above graph, connect the 2.4G/72M receiver channel 1-10 to the UHF
transmitter, insert the V (5V) and G (ground wire) to power-up the receiver.
3. After checking the wire connection, please insert the balance charge port of the 3S lithium battery
into the ‘3S port’ in the bottom left corner to supply power. If receiver signal is identified, the status
LED will flicker fast; otherwise it will flicker slowly (one second one time).
Warning
: In Repeater mode, in order to archive
"Turn off radio TX" return
, you need to set 2.4G/72M
receiver
’s failsafe. (To archive
"out of control range" return
, you need to set the Arkbird UHF receiver
’s
failsafe); please correctly set up both receiver, and test before the flight as:
1. Close the radio controller
2. Close 433 transmitter power
Check if both failsafe is OK
, otherwise it may not be able to give Return to Home failsafe control.
