11
Swing the airplane from left to right, elevon surface on the right side should face down, its left side should face up.
If the orientation of elevon surface is not right, please note it and change negative and positive value of roll in OSD.
2.
Nosing down the airplane, then both the left and right elevon surfaces should face up, as per:
Nosing up the airplane, then both the left and right elevon surfaces should face down, as per:
If the orientation of elevon surface is not right, please note it and change negative and positive value of pitch in
OSD.
Step 5: Further configuration
After completion of Step 4, Set the switches so Manual Mode
should be the flight mode and throttle value
should be the lowest. Then move your aileron stick to the rightmost or leftmost. Don’t touch anything else until the
OSD shows the following:
* If the OSD cannot display menus as the photo, please refer to Q&A attached to the user instruction.
The mark in red square is cursor. It functions as:
×
√
×
√
√
×
