-16-
Set CTL Parameters
Roll Ctl
Roll Control(%)(equivalent to travel range on radio,
Please adjust the travel
range on OSD, do not adjust through radio
)
Pitch Ctl
Pitch Control (%)
Yaw Ctl
Yaw Control (%)
------------------------------------------------------------------------------------------------------------ ------------------------------------
Neutral Check
Neutral Point Check:
Neutral point alignment needed under first installation, not used for weeks,
or temperature variation is more than 10 degrees.
Aileron
all the way to the right
means it is waiting autopilot be put down, OSD
shows “Waiting Neutral Point Check.”
Put the autopilot paralleled to the ground (Please prop up if there is a landing
gear), and
move CH1 left and right
to do 3-seconds neutral point check. Aileron
will be back to center once finished.
Note:
Pushing CH5 and CH6 to minus (0%) and moving CH1 stick to left or right
side
within 3 seconds after power on can also enter neutral point check.
Launch Assist
After turning the function on (ON), "Launch Assist" function which can help to control throttle and reduce
the difficulty of take-off in manual throwing process.
Switch to balance mode and the throttle will not be started.
Run up with aircraft in hands, when the speed is higher than 5kmph, the throttle will start output and
automatically control the take-off.
Note:
This function can only be started when more than
6 GPS satellites
are available. In order to ensure
safety, in run-up process, lower the throttle stick, lower the aircraft head down 35° or stop the run-up, throttle
will be disabled. When the aircraft flies above 15m high, or more than 100 m away, launch assist will be disabled
and throttle will under normal control.
----------------------------------------------------------------------------------------------------------------
Custom Mode
Custom Mode(CH5> 50% and 30% < CH6 < 70%):
RTH
: Return to Home(Default)
Way Point
: Way Point Mode, it is able to trace the Way Point Set by
WayPoint menu.
HOVER
: Hover mode, regard the hover position as balance position
Gyro
: Gyro Mode, it will do compensation for unintentional attitude
