Home Station User Guide
7. Place the shielding on top of the drive.
8. Fasten the screws from the side to
mount the hard drive to the frame.
9. Place the assembled drive back into
the base and connect the cables.
10. Fasten the screws to mount the frame
to the base.
11. Align the top cover with the base and
push lightly into place.
12. Fasten the screws to finish the
assembly.
Note: For the Home Station 1&2, set the jumper of the IDE hard drive to master or factory
default.
Page 7 / Chapter 2 - System Setup