7
9
10
6
8
To attach
optional
camera/pico projector adapter, unscrew shaft knob and
remove phone holder, ring, and ball adapter. Attach the 25mm ball end of the
camera adapter to the shaft and tighten clockwise to secure.
Unscrew mount’s knob to loosen grip. Place mount around pole and
tighten knob to secure.
Push down on lower legs of spring-loaded holder to insert tablet.
Ring light clips onto phone.
For instructions on how to assemble tablet holder, refer to included
TAB001 manual. Attach tablet holder by inserting the mount’s Dual
T-Tabs into the holder’s Dual T-Slots.
Adjust the height of the pole by loosening the adjustment collar
counterclockwise. Tighten clockwise to set height.
Consumer Hotline:
USA
(800) 841-0884
INT’L
(626) 254-9005
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan and USA
© Copyright 2018 Arkon Resources, Inc.
Safety Precautions
Always use two hands (one on shaft, and one on base) when carrying.
Failure to properly secure the stand’s shaft to the base could cause
bodily injury or harm. The Arkon Pro Stand is designed for use with
smartphones and small cameras. If using heavier devices, be sure to add
a counterbalance in order to prevent the stand from falling over. Arkon
Resources, Inc. is not responsible for any damages caused to your device
or yourself due to the installation or use of this mount.
!
page 2
Tightening
Knob
RCBTABLED
| Remarkable Creators Video Phone Stand Bundle
rev.053118
OPTIONAL
