Arkpak AP730, Instruction Manual

POWERING A DEVICE

It is possible to power many types of 240V and 12V devices from the various outlet sockets on the 
ArkPak (refer to overview on page 2 and table on page 13). When powering a device the main data 
screen will show discharge cycle. It is okay to use the ArkPak to power a device whilst it is connected to 
mains power or DC power. To power a device from one of the outlets the isolator switch must be in the 
“on” position. Otherwise, the isolator switch should be in the ‘off’ position for safety. If the ArkPak is not 
charging the screen will always show discharge cycle. Please note the isolator connects or disconnects 
the outlets from the battery and does not affect the smart charger.

It is possible to power a device with the LCD screen turned off since the various output sockets are 
connected to battery via the main isolator switch and not via the smart charger.

Refer to page 10 on how to use the AC outlet. Details of other outlets are on page 13. Please note fuses 
for outlets are underneath the lid. If the battery cables are corrected in reverse polarity this will blow the 
10A fuse marked “main” under the lid.

Fuse information

Fuse for 240V inverter

Fuse for cigarette socket 2

Fuse for cigarette socket 1

Main fuse for smart charger

9

WARNING - If charging ArkPak from vehicle using car charging lead (refer to page 2) and 

powering a fridge at the same time ensure fridge is not earthed to vehicle chassis.