OPERATING INSTRUCTIONS
6
BEFORE WASHING
•
Prepare wash load. For the best cleaning results, mix large and
small articles within each load.
•
After filling inner tub with water and soap, lift up Washer Lid
and drop articles loosely into the inner tub. Fill only up to half
point of tub with garments. Do not pack articles in tightly.
Articles should move freely through wash water, allowing them
to roll over, sink and then reappear during wash cycle.
•
Overloading inner tub can result in poor washing and rinsing
results, wrinkling and tearing of garments, and malfunction of
unit.
•
Long sleeves, pants legs or sheets should be tied into a loose
knot or placed inside of a mesh bag to prevent excessive
tangling or wrinkles.
•
Metal zippers and buttons should be closed to reduce prevent
scratching or other damage to machine or other clothing.
•
For more heavily soiled garments, allow items to soak for 10 to
20 minutes before you start wash cycle.
OPERATION
WASHING CYCLE
1. Close the Washer Lid. Turn Wash Selector dial to an
appropriate setting:
NORMAL — for full loads or loads consisting of thicker
fabrics. Also used as a default setting when washer is off.
SOFT — for light loads or loads consisting of delicate
fabrics.
2. Turn Wash Timer dial to desired range of time, between 0 to 15
minutes. Allow cycle to complete.
3. At the end of wash cycle, turn Wash Selector dial to the “Drain”
setting. Allow unit’s automatic pump to remove all water through
drain hose.
4. When no more water flows from drain hose, turn Wash
Selector to the “Normal” position.
You are now ready to begin rinse and spin dry cycles.
