OPERATION
RINSE CYCLE
1. Leave Water Inlet Hose connected to the faucet.
Disconnect the other end from Washer Inlet. Connect
it to Spin Dryer Water Inlet.
2. Lift Spin Dryer Splash Lid and Stability Cover. Turn
faucet to desired temperature and fill dryer tub. You
may also fill it directly with a bucket or pitcher.
3. Insert garments into Spin Dryer, only a few articles at
a time, loosely and evenly. Do not pack articles in
tightly, to allow free movement during drying process.
4. Place the Balance Guide into dryer tub and push
down, until it touches the garments. Close Stability
Cover and Splash Lid.
5. Turn Spin Timer dial to “5”. Allow dryer to spin, rinsing
clothing in the water. The unit’s automatic pump will
push water through drain hose. You may also use the
“Drain” setting on Wash Selector, for an extra boost.
6. The unit will begin to wick water away from the
garments and automatically drain it through hose.
7. Repeat rinse cycle as needed.
* If you prefer, you can rinse by leaving garments in
the Washer. Simply re-fill the tub, repeat wash cycle
and drain water until it runs clear from the hose.
SPIN DRY CYCLE
NOTE: IF DESIRED, IT IS SAFE TO RUN THE SPIN DRYER
AND THE WASHING MACHINE AT THE SAME TIME.
1. After garments have been throughly rinsed, do not re-
fill Spin Dryer tub with water. Place garments loosely
and evenly spaced within the tub.
2. If needed, place Balance Guide on top of garments.
Close Stability Cover and Splash Lid.
3. Turn Spin Timer to “5”, and allow Spin Dryer to wick
water away. The unit’s automatic pump will push water
through drain hose. You may also use the “Drain”
setting on the Wash Selector, for an extra boost.
4. When the cycle is complete, remove garments and
hang on a clothing rack or clothesline to finish drying.
7
