4. INTENDED USE
Only use this appliance to blast chilling/freezing
food for commercial purposes.
• Any other use may lead to damage to the appli-
ance, other user property, or personal injury.
• No liability will be accepted for damage resulting
from improper use or non-compliance with this
manual.
• Operating the appliance for any other purpose
means misuse of the appliance
.
5. LOCATION AND INSTALLATION
• Remove the appliance from the packaging. Make
sure that all protective plastic film and coatings
are thoroughly removed from all surfaces. To
prevent injury or damage to the unit, we recom-
mend that the appliance should be unpacked and
set up by two people.
• The climatic class can be found on the rating
plate. It specifies the ambient temperatures at
which the appliance may be operated. The rating
plate can be found behind the appliance.
Climate Class
Max. Ambient Temperature
Relative Humidity
3
25
60%
4
30
55%
5
40
40%
• Maintain a distance of 10 cm between the appli-
ance and walls or other objects for ventilation.
Increase this distance if the appliance is near an
a heat source.
•
• The appliance should be placed on a solid flat
and stable floor to reduce noise and vibration.
Level the appliance by adjusting the feet.
• Avoid locating the unit in direct sunlight or near
heat sources such as ovens or radiators.
• Please make sure the appliance is properly
ventilated.
• Check that the power supply and voltage used
comply with the details on the rating plate. The
plug must be accessible after installation.
• Correctly connect and disconnect the plug. When
inserting ensure the plug is fully engaged. While
unplugging hold the body of the plug. Never pull
the supply cord directly.
• Is advisable to install a bipolar switch with a NC
contact (Normal Close) for the wire section at
least 3 mm. between socket and the appliance.
This switch is mandatory when the load exceeds
1000 watts or when the blast chiller is connected
directly without plug. The thermal-braker switch
must be placed near the blast chiller so that it
can be clearly visible by the technician in case of
maintenance.
• Blast chiller is equipped with a built-in refriger-
ation engine, is necessary to avoid obstruct the
air circulation of the unit in correspondence at
front grille, in this way it will allow a correct air
exchange. Avoid depositing products or other
materials on the perimeter of the blast chiller.
Remember that a rise of ambient temperature or
insufficient air to the condenser of the refriger-
ation unit, reduce the performance of the blast
chiller with possible deterioration of the products
and with more energy consumption.
• If the unit is to be shut down for long period,
switch it off and disconnect the plug from socket
6
EN
Summary of Contents for 236123
