Safety & Warnings
Warranty Agreement
1) The product shall be installed and serviced by a qualified person.
2) IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a water proof
enclosure.
3) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4) Please check if the output voltage of any LED power supplies used comply with the working voltage of the
product.
5) Never connect any cables while power is on and always assure correct connections to avoid short circuits
before switching on.
6)
7) For update information please consult your supplier.
Please ensure that the cable is secured tightly in the connector
1) We provide lifelong technical assistance with this product:
5-year warranty. We print date on every products, for example :1125 means year 2011,week 25.The
warranty is for free repair or replacement and covers manufacturing faults only.
For faults beyond the 5-year warranty we reserve the right to charge for time and parts.
2) Limited Warrenty
Any defects caused by wrong operation.
Any damages caused by unauthorized removal, maintenance, modifying, incorrect connection and
replacement of chips.
Any damages due to transportation, vibration etc. after purchase.
Any damages caused by earthquake, fire, lightning, pollution and abnormal voltage.
Any damages caused by negligence, inappropriate storing at high temperatures and humidity or near
harmful chemicals.
Product has been updated
3) Repair or replacement as provided under this warranty is the exclusive remedy to the customer.
Operation
Learning (matching)
a. Do wiring according to connection diagram
b. Wake up the remote control by touching ON/OFF button.
c. Press learning button on receiver.
d. Touch any zone button on remote control.
e. Then touch color wheel.
f. Connected LED light will blink to confirm zone designation.
g. Press at learning button on receiver over 5 seconds until LED light flash, then delete the learned ID.
Note 1: To choose a master from slaves by jumper for each zone.
Short circuit for master.
Open circuit for slave.
Each zone only can set one master controller. After a period of time, the master will do synchronization
operation to keep the same color or mode of all slaves in one zone.
Note 2: Each remote control 4 zones (areas) receivers, each area can be learned as many receivers as
we can.
Each receiver maximally can be controlled by 8 different remote controllers.
Choose zone number , for example, and , then touch , choose the color you want,
zone 1 and 3 will indicate corresponding color as we touched.
Brightness Up & Down Button
Short/Long press button
to dim down brightness of RGB channels, Short/long press
button to dim
up RGB channels.
“W” channel is separated from RGB channels, so we can only long press button to dimming“W” channel.
Running Mode & Speed Button
a. Short press
,
mode will run. Press it once, it runs one mode. Press button again, it stops, then press
one more time, it will enter next mode. There are total 10 build-in modes.
b. Long press
when mode is running, Fist long press will speed up the color moving, long press again to
speed down the color moving.
Color wheel
W+ Button
a. RGB channel will mix to three different white: warm white, nature white and cold white by short press
For example: first press---warm white, press again---nature white, third press again—cold white, fourth
press—warm white………………
b. Fast click twice to switch off RGB channel.
W+
W+
Save and recall button
Save color: select zones from
select a color from
long press one save button
from S1,S2,S3 for 2-3 second
LED lighting flash twice
indicate save successful
a.
b. Save running mold: select zones from
select a moving mode from
long press one save button from
S1,S2,S3 for 2-3 second
LED lighting flash twice
indicate save successful
c.
Recall: select zone button which we want recall from 1-4, then short press save button S1,S2,S3.
