A4.10
Powering down the processor with system driven L2 flush
When powering down the processor, the PDMERCURY, PDL2, and PDCPU power domains are shut
down and all state is lost.
To power down the cluster, apply the following sequence:
Procedure
1. Ensure all cores are in shutdown mode, see
A4.6 Powering down an individual core
.
2. If the ACP interface is configured, ensure that any master connected to the interface does not send
new transactions, then assert
AINACTS
. This is necessary to prevent ACP transactions from
allocating new entries in the L2 cache while the hardware cache flush is occurring.
3. Assert
L2FLUSHREQ
HIGH.
4. Hold
L2FLUSHREQ
HIGH until
L2FLUSHDONE
is asserted.
5. Deassert
L2FLUSHREQ
.
6. In an ACE configuration, assert
ACINACTM
or, in a CHI configuration, assert
SINACT
. Then, wait
until the
STANDBYWFIL2
output is asserted to indicate that the L2 memory system is idle. All
Cortex
‑
A35 processor implementations contain an L2 memory system, including implementations
without an L2 cache. This applies to implementations that use the mini-SCU and implementations
that use the SCU.
7. Activate the cluster output clamps.
8. Remove power from the PDMERCURY and PDL2 power domains.
A4 Power Management
A4.10 Powering down the processor with system driven L2 flush
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
A4-69
Non-Confidential
Summary of Contents for Cortex-A35
