A4.13
Exiting Dormant mode
As part of the exit from Dormant mode to Normal state, the SoC must perform a cold reset sequence.
The SoC must assert the reset signals until power is restored. After power is restored, the cluster exits the
cold reset sequence, and the architectural state must be restored.
To exit Dormant mode, apply the following sequence:
1. Apply a normal cold reset sequence. You must apply resets to the cores and the L2 memory system
logic until power is restored. During this reset sequence,
L2RSTDISABLE
must be held HIGH to
disable the L2 cache hardware reset mechanism.
2. When power has been restored, release the L2 cache RAM input clamps.
3. Continue a normal cold reset sequence with
L2RSTDISABLE
held HIGH.
4. The architectural state must be restored, if required.
A4 Power Management
A4.13 Exiting Dormant mode
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
A4-72
Non-Confidential
Summary of Contents for Cortex-A35
