C11.40 Single-Shot Comparator Status Register 0
The TRCSSCSR0 characteristics are:
Purpose
Indicates the status of the single-shot comparator. TRCSSCSR0 is sensitive to instruction
addresses.
Usage constraints
• Accepts writes only when the trace unit is disabled.
• The STATUS bit value is stable only when TRCSTATR.PMSTABLE==1.
Configurations
Available in all configurations.
Attributes
See
31 30
3 2 1 0
RES
0
STATUS
DV
DA
INST
Figure C11-39 TRCSSCSR0 bit assignments
STATUS, [31]
Single-shot status. This indicates whether any of the selected comparators have matched:
0
Match has not occurred.
1
Match has occurred at least once.
When programming the ETM trace unit, if TRCSSCCRn.RST is b0, the STATUS bit must be
explicitly written to 0 to enable this single-shot comparator control.
[30:3]
Reserved,
RES0
.
DV, [2]
Data value comparator support:
0
Single-shot data value comparisons not supported.
DA, [1]
Data address comparator support:
0
Single-shot data address comparisons not supported.
INST, [0]
Instruction address comparator support:
1
Single-shot instruction address comparisons supported.
The TRCSSCSR0 can be accessed through the external debug interface, offset
0x2A0
.
C11 ETM registers
C11.40 Single-Shot Comparator Status Register 0
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
C11-786
Non-Confidential
Summary of Contents for Cortex-A35
