C11.53 Integration Instruction ATB Out Register
The TRCITIATBOUTR characteristics are:
Purpose
Sets the state of the output pins shown in the following table.
Usage constraints
• Available when bit[0] of TRCITCTRL is set to 1.
• The value of the register sets the signals on the output pins when the register is written.
Configurations
Available in all configurations.
Attributes
See
31
0
AFREADY
Reserved
2 1
ATVALID
8 7
9
10
BYTES
Reserved
Figure C11-52 TRCITIATBOUTR bit assignments
For all non-reserved bits:
• When a bit is set to 0, the corresponding output pin is LOW.
• When a bit is set to 1, the corresponding output pin is HIGH.
• The TRCITIATBOUTR bit values always correspond to the physical state of the output pins.
[31:10]
Reserved. Read undefined.
BYTES, [9:8]
Drives the
ATBYTESMn[1:0]
output pins.
[7:2]
Reserved. Read undefined.
AFREADY, [1]
Drives the
AFREADYMn
output pin.
ATVALID, [0]
Drives the
ATVALIDMn
output pin.
The TRCITIATBOUTR can be accessed through the external debug interface, offset
0xEFC
.
C11 ETM registers
C11.53 Integration Instruction ATB Out Register
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
C11-800
Non-Confidential
Summary of Contents for Cortex-A35
