Clamp
Meter
10
6-5 Resistance Measurement
Switch the main function to
range.
Connect the red test lead to the
“+” terminal and the black lead to
the "COM" terminal.
Connect tip of the test leads to
the points where the value of the
resistance is to be measured.
Read the result from the LCD.
Note :
When measuring resistance in a
circuit, make sure any power on
the circuit is turned off and any
capacitors are discharged.
7. CHANGING THE BATTERY
When the battery voltage drops below that required for proper
operation of the instrument, the battery symbol will appear on the
LCD display and the battery should be changed.
Before changing the battery, switch the main dial to “OFF ”and
disconnect test leads.
Open the back cover using a screwdriver.
Replace the old batteries with two new 1.5V (AAA Size) batteries.
Close the back cover and tighten the screw before using the meter.
Summary of Contents for Pro95
Page 1: ...Model Pro95 TRUE RMS MILLIAMP CLAMP METER...
Page 2: ......
Page 15: ......
Page 16: ...GCBARM265 R0200 Armada Technologies www armadatech com...
