Armada Pro95i, Instruction Manual

Clamp Meter 

1

1. 

     SAFETY INFORMATION 



  Do not operate the tester if there is any sign of damage to the tester 

or the test leads. 



  Check the main function dial and make sure it is in the correct 

position before each measurement. 



  Do not perform resistance and continuity tests on a live power 

system. 



  Do not apply voltage between the test terminals and test terminal to 

ground that exceed the maximum limits stated in this manual. 



  Keep your fingers behind the protection ring on the test probes 

when using the test leads. 



  Change the battery when the 

 symbol appears to avoid incorrect 

data. 

Environmental Conditions 

Operation Temperature: 0°C to 40°C(32°F to 104°F); < 80 % RH 
Storage Temperature: -10°C to 60°C(14°F to 140°F

);

 < 80 % RH 

Explanation Symbols 

Attention refer to operation Instructions. 

Dangerous voltage may be present at terminals. 

This instrument has double insulation. 

Approvals:   

EN61010 600V CAT III

2.  GENERAL SPECIFICATION 

Digital Display: 

4 digital liquid crystal(LCD), maximum reading 6000. 

Polarity: 

When a negative signal is applied, the “

” signal appears.  

Low Battery Indication: 

When the battery voltage is below that required for proper operation 
then the 

 symbol will appear on the LCD display. 

Sample Rate:  

2 times/sec for digital data. 

N2068